Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
5. Setting Up Windows Server 2003 R2 x64 Edition
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
176
Chapter 1 Installing Windows
10. After copying the files, the following window appears. Click [Close].
The server restarts.
Note
You do not need to press <F3> key at this time.
11. Log on to the system with a user account that has administrative privileges (such as Administrator).
Important
The screen as shown below appears when Windows starts. Do not click [OK]
on this screen. Proceed to Step 12.
If you click [OK], "KB921411" will not be applied.
Go to Step 16, and click [Cancel] on the screen to install Starter Pack. Then,
perform from Step 1 of (2) When using Internal Flash Memory.
If you installed the Windows Server 2003 x64 Edition with Service Pack 2, go to step 15.
12. Select Run from the Start menu, and then execute the following command:
System drive:\StartPKG\w2k3amd\qfe\enu\kb921411.exe