Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
5. Setting Up Windows Server 2003 R2 x64 Edition
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
165
Chapter 1 Installing Windows
20. If a RAID controller or an optional mass storage controller is used, press <F6> key while either of the
following messages is displayed. If not, go to step 25 without pressing <F6> key.
"Setup is inspecting your computer's hardware configuration" (on the top of the screen)
"Press F6 if you need to install a third party SCSI or RAID driver…" (on the bottom of the screen)
Tips
• Note that nothing changes on the screen even when <F6> key is pressed.
• If the OEM drivers list is not displayed at step 22, 24, check the boot order of the
Flash FDD on BIOS settings.
21. The following message appears.
If a RAID controller is used on the server, press <S> key and go to step 22.
If not, go to step 23.
22. Select the following from the driver list, and then press <Enter> key.
When using N8103-128 RAID Controller:
Promise SuperTrak EX Family Controller - 64bits platform
When using N8103-149/150/151 RAID Controller:
LSI MegaRAID SAS RAID Controller Driver
When using Onboard RAID Controller (LSI Embedded MegaRAID):
LSI Embedded MegaRAID (Windows 2003 64-bit)
The screen shown in step 21 appears again. Go to step 23.
23. If N8103-104A is connected, press <S> key and go to step 24.
If not, press <Enter> key and go to step 25.
24. Select LSI Fusion-MPT SAS Driver (Server 2003 x64), and then press <Enter> key.
The screen shown in step 21 appears again. Press <Enter> key and go to step 25.