Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
5. Setting Up Windows Server 2003 R2 x64 Edition
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
164
Chapter 1 Installing Windows
17. Continue setup according to on-screen message.
If the Copy the OEM drivers to the removable media checkbox is selected in step 13, the following
window appears. Follow the onscreen instructions and continue the operation.
When the following message appears, set OS installation media, and click [OK].
18. The server automatically restarts.
To use OEM driver, change boot priority of Flash FDD on BIOS settings, after restarting the server.
Select Boot, Floppy Drive BBS priorities, Boot Option #1, and then specify the Flash FDD used.
19. Run from the OS installation media.
If a bootable operating system is already installed on the hard disk drive, press <Enter> key while the
message “Press any key to boot from CD or DVD…” is displayed on the top of the screen.
The boot sequence proceeds and the following message appears.
Note
If this message does not appear, reboot the server and retry.
This step is unnecessary if no bootable operating system exists.