Installation Guide

5. Setting Up Windows Server 2003 R2 x64 Edition
Express5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
152
Chapter 1 Installing Windows
5.
Setting Up Windows Server 2003 R2 x64 Edition
Set up Windows Server 2003 R2 x64 Edition.
5.1
Before Starting Setup
Read through the cautions explained here before starting setup.
: Setting up of Pre-installed model
: Confirm during Setup with EXPRESSBUILDER
: Confirm during Setup with OS standard installer
(1/3)
Setup Items to confirm
– –
Windows family The following editions of the Windows Server 2003 family may be installed.
• Windows Server 2003 R2 Standard x64 Edition
• Windows Server 2003 R2 Enterprise x64 Edition (supported by R110e-1 only)
Inquiries about installing other editions may be made at your sales dealer or maintenance
service company. When applying Service Pack 1, refer to the following About Windows Server
2008 R2 and Windows 7 Service Pack 1:
Note
Setup with EXPRESSBUILDER cannot be used.
– –
License
authentication
If Windows Server 2003 R2 x64 Edition is installed from Backup CD-ROM, the license is
already activated. If Windows Server 2003 R2 x64 Edition is installed from an OS CD instead
of Backup CD-ROM, a product key is required for license authentication. At this time, the
product key must be the same as that indicated on the COA label of Windows Server 2003 R2
x64 Edition.
For details, refer to Chapter 1 (5.6 License Authentication).
Important
•
Activate within 30 days following installation. The system is locked if 30
days have passed without activation.
Hardware
configuration
The following hardware configurations require special procedures.
– –
• When using the OEM drivers, be sure to change the boot order of the Flash FDD on the
BIOS settings as follows:
Select Boot, Floppy Drive BBS priorities, Boot Option #1, and then specify the Flash
FDD used.
Note
Change as instructed in Chapter 1 (5.2.3 Setup procedure).