Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
4. Setting Up Windows Server 2008
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
151
Chapter 1 Installing Windows
(2) Changing drive letter assignments
To change the drive letter, follow the steps below. But these steps cannot change drive letter assignments for
the system volume or boot volume. If you want to change them, re-install the Windows.
1. From the Start menu, right-click Computer and then select Management. Next, launch Server
Manager.
2. From the window on the left, select Storage and then Disk Management.
3. Right-click the volume whose drive letter you want to change, and then select Change drive letter and
path.
4. Click [Change].
5. Click [Assign next drive letter], and then select the drive letter you want to assign.
6. Click [OK].
7. When the following message appears, read the contents and then click [OK].
Some programs are dependent on drive letters, and may
not run properly. Continue?
8. Close the Server Manager.