Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
4. Setting Up Windows Server 2008
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
141
Chapter 1 Installing Windows
(4) Procedure for deleting team
Important
You must delete teams from Broadcom Control Suite.
You cannot delete the team from the team adapter displayed in the Device
Manager.
1. Double-click Broadcom Control Suite in the Control Panel window.
Broadcom Advanced Control Suite starts.
2. Set a Filter in a TEAM VIEW, right-click the adapter to be used for the team, and then select Delete
Team from the short-cut menu.
Note
When the message below appears, select [Yes].
"The selected team will be deleted from system, do you want to
proceed?
NOTE:
Applying the changes will temporarily interrupt the
network connection. The process may take several
minutes and the connection will resume afterwards."
3. Insert EXPRESSBUILDER DVD into the optical disk drive.
If Autorun Menu appears, close the menu window.
Tips
You do not have to insert EXPRESSBUILDER DVD if Starter Pack was installed
from Internal Flash Memory. Proceed to the next step.