Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
4. Setting Up Windows Server 2008
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
136
Chapter 1 Installing Windows
− Smart Load Balancing (Auto-Failback Disable) (with Standby Member)
(1) Select Use the following member as a standby member.
(2) Select the adapter that is to be a standby member from the drop-down list.
(3) Select Enable Auto-Failback Disable mode.
(4) Click [Next].
Note
Enable Auto-Failback Disable mode is cleared while editing the team. Select it
again.
8. Select Yes for Configure LiveLink?, and then click [Next].