Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
4. Setting Up Windows Server 2008
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
116
Chapter 1 Installing Windows
Tips
• If using Internal Flash Memory, you do not need to remove the OS installation
media.
• At this time, the message "The Installation media can be a floppy disk, CD,
DVD, or USB flash drive." appears on the screen, use the supplied
EXPRESSBUILDER DVD or Internal Flash Memory.
29. Specify one of the following locations, and then click [OK].
(When using EXPRESSBUILDER, select the optical disk drive. When using Internal Flash Memory,
select the volume of INTER-FLASH.)
When using the N8103-128 RAID Controller :
− Windows Server 2008 x64
\024\win\winnt\oemfd\ws2008x64\stexstpt
− Windows Server 2008 x86
\024\win\winnt\oemfd\ws2008\stexstpt
When using the N8103-149/150/151 RAID Controller :
− Windows Server 2008 x64
\024\win\winnt\oemfd\ws2008x64\megasas2
− Windows Server 2008 x86
\024\win\winnt\oemfd\ws2008\megasas2
When using the onboard RAID Controller (LSI Embedded MegaRAID) and a USB-DVD drive :
− Windows Server 2008 x64
\024\win\winnt\oemfd\ws2008x64\megasr1
− Windows Server 2008 x86
\024\win\winnt\oemfd\ws2008\megasr1
Tips
The driver does not have to be loaded at this time if it was loaded in steps 22 and
23.
30. Select the necessary driver from the driver list shown, and then click [Next].
When using the N8103-128 RAID Controller
[Promise SuperTrak SAS 6G RAID Controller]
When using the N8103-149/150/151 RAID Controller
[LSI MegaRAID SAS 9267-8i]
When using the onboard RAID Controller (LSI Embedded MegaRAID) and a USB-DVD drive
[LSI Embedded MegaRAID]
31. If you used EXPRESSBUILDER DVD, remove it and then insert the OS installation media.
32. Select the disk in which the partition will be created, and then click Drive options (advanced)
If a partition has already been created, go to step 35.
33. Click [New], enter the partition size into the size input box, and then click [Apply].
Note
When installing the OS to a disk of over 2,097,152 MB (2 TB), the partition
size can only be set to 2,097,152 MB or less.