Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
4. Setting Up Windows Server 2008
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
115
Chapter 1 Installing Windows
26. When the following window appears, confirm the content of the license agreement. If you agree, select
I accept the license terms and then click [Next].
27. When the following message appears, select the installation type.
Select Custom (advanced) in this case.
28. "Where do you want to install Windows?" window appears.
Note
If the driver was loaded in steps 22 to 23, or if not using a RAID Controller, go to
step 32.
Click Load Driver.
If the following message appears, replace the OS installation media and EXPRESSBUILDER DVD in
the optical disk drive, and then click [Browse]. Next, go to step 29.
Load Driver
To install the driver needed to access your hard drive, insert
the installation media containing the driver files, and then click
OK.
Note: The installation media can be a floppy disk, CD, DVD, or
USB flash drive.
[Browse] [OK] [Cancel]