Installation Guide
Table Of Contents
- Cover
- Documents Provided with This Product
- Contents
- Notations Used in This Document
- Trademarks
- Regulatory Notices
- Warnings and Additions to This Document
- Chapter 1 Installing Windows
- 1. Before Starting Setup
- 2. Setting Up the Operating System
- 3. Setting Up Windows Server 2008 R2
- 4. Setting Up Windows Server 2008
- 4.1 Before Starting Setup
- 4.2 Setup with EXPRESSBUILDER
- 4.3 Setup with OS Standard Installer
- 4.4 Installing Starter Pack
- 4.5 Setting Up Device Drivers
- 4.6 Specifying PAE Option
- 4.7 Installing the Bundled Software
- 4.8 License Authentication
- 4.9 Applying Service Pack
- 4.10 Installation When Multiple Logical Drives Exist
- 5. Setting Up Windows Server 2003 R2 x64 Edition
- 6. Setting Up Windows Server 2003
- 7. Setup for Solving Problems
- 8. Windows OS Parameter File
- Chapter 2 Installing the Bundled Software
4. Setting Up Windows Server 2008
press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)
107
Chapter 1 Installing Windows
6. Select Set up this computer from Top Menu of EXPRESSBUILDER, and then click [Next].
7. Set parameters on this menu according to your requirement.
When not using parameter file: Go to Step 8.
When using a parameter file: Go to Step 9.
Note
When setting up again, an already saved parameter file can be read, so that you
can skip inputting parameters in the wizard.
8. If you do not use a parameter file, select an OS from the pull-down menu in [Install Windows], and click
[Next].
On this dialog, select "Windows Server 2008 x86" from the pull-down menu.
→ Go to Step 10.
9. If you use a parameter file, select [Load a parameter file] and click [Next]. Load a parameter file
according to displayed instructions.