User's Guide

Configuring Your Server 4-13
Memory Configuration
Option Parameter Description Your Setting
Installed memory –
Indicates the total capacity of the base
memory. (View only)
Available under
4GB
–
Indicates the capacity of memory
available in the area under 4GB. (View
only)
DIMM1-4 Status Normal
Disabled
Not installed
Error
Indicates the current memory status.
"Normal" indicates the normal status,
"Disabled" indicates a memory error, "Not
installed" indicates no DIMM installed,
and
"Error" indicates the system is forcibly
started with memory error. (View only).
Memory Retest Yes
[No]
Causes BIOS to retest all memory on the
next boot. Automatically reset to "No" at
the next boot.
Extended RAM
Step
1MB
[Disabled]
"1MB" indicates that the memory test is
done in the unit of 1MB.
"Disabled" indicates that only memory
initialization is done.
Only pressing Space is acceptable to
suspend the test during the memory test.
[ ]: Factory-set
PCI Configuration
Option Parameter Description Your Setting
PCI Slot 1-4
Option ROM
[Enabled]
Disabled
Displays the submenu to specify whether to
enable or disable the BIOS on the device
(board) connected to PCI slot.
Set this item to "Enabled" when the RAID
Controller or SCSI controller is connected
with the hard disk drive which contains an
OS.
Set this item to "Disabled" when the LAN
controller which contains ROM BIOS is
used but the board does not provide
network booting.
Disabling Option ROM Scan saves memory
consumption and time for startup.
[ ]: Factory-set
IMPORTANT: If the RAID Controller, LAN board (network boot), or
SCSI controller is connected with the hard disk drive that does not
contain an OS, set the parameter for "PCI Slot x Option ROM" (x: slot
containing the PCI card) to "Disabled".