User's Guide

D-24 Installing Windows Server 2008 R2
6.
Select a team mode, and then click [Next].
IMPORTANT: Following team types are supported.
 Adapter Fault Tolerance
 Adaptive Load Balancing
 Static Link Aggregation
 Switch Fault Tolerance
7. Click [Finish].
IMPORTANT: Teaming an adapter with standard network adapter
and optional network adapter will cause the following message appear.
Click [OK] and continue the setting.
"One or more adapters in the team do not support true NDIS6.20
Receive-Side Scaling, Receive-Side Scaling will be disabled for the
team, Disabling Receive-Side Scaling will negatively impact the
performance of the team."
8. Click [TEAM: "Team name"] from [Device manager] → [Network adapters] to modify
the team. Click [Settings] tab and click [Modify Team] button.
9. Refer to the following procedure to set the team member adapter priority status.
– Set Primary
Point the adapter and click [Set Primary] button.
– Set Secondary
Point the adapter and click [Set Secondary] button.
NOTE: Adapter priority config can be confirmed by the following
procedure:
1. Click [TEAM: "Team name"] from [Device manager] → [Network
adapters].
2. Click [Settings] and confirm Adapters in team list.
10. Click [Test Switch] → [Run test] to confirm the adapter team is properly setup.
Confirm the result in [Test results].
11. Restart the system
Remove Team
1. Open the [Device Manager].
2. Click [Network adapters], and open [TEAM: "Team name"] properties.