User's Guide

9-12 Upgrading Your Server
Installation
Follow the procedure as described below to install 3.5-inch hard disk drives.
1. Configure the operation mode of hard disk drives according to the manual supplied with
the hard disk drive.
Hard disk drive Cage to Install Serial ATA connector on mother board
First hard disk drive Slot 0 Serial ATA connector 0
Second hard disk drive Slot 1 Serial ATA connector 1
Third hard disk drive Slot 2 Serial ATA connector 2
Fourth hard disk drive Slot 3 Serial ATA connector 3
2. See the section "Preparing for Installation and Removal" described earlier to prepare.
3. Remove the side cover.
4. Disconnect the interface cable and power cable from the hard disk drive if connected.
Serial ATA connector 0
Serial ATA connector 1
Serial ATA connector 3
Serial ATA connector 2
Mother board