User's Guide

Installing the Operating System with Express Setup 5-77
Setting WOL
Refer to the following procedure to enable WOL.
When PROSet is not installed
1. Start Device Manager.
2. Point to [Network adapters] and double click [Intel(R) 82547L Gigabit Network
Connection] to open the adapter [Properties].
3. Click [Power Management] tab and change setting in [Wake On LAN] according to the
following list.
Setting item Change setting
"Allow the computer to turn off this device to save power" ON
"Allow this device to bring the computer out of standby" ON or OFF
IMPORTANT:
■ Set "Allow this device to bring..." to "ON", WOL by
DirectedPacket
(*1)
or MagicPacket will be available on Standby
state.
■ WOL by DirectedPacket is not available on Hibernate and
Shutdown state.
(*1) Packet with the Ethernet address of the adapter in ethernet header
or Packet with an IP address assigned to the adapter in IP header.
4. Click [Advanced] tab and point to [Enable PME].
5. Set the "Enable" in [Value].
6. Click [OK].
7. Restart the system.