Technical Reference Guide

ftServer Setup Menus
5-12 Express5800/320Ma: Technical Reference Guide
Base I/O address 3F8 IRQ 4
2F8 IRQ 3
3E8 IRQ 4
2E8 IRQ 3
Sets the base I/O address for the
serial port.
Serial Port 1
Connection
Internal Modem
Serial Connector
Specifies whether Serial Port 1 is
used by the ASN modem or is
available for general use.
Do not select Internal Modem for
for Serial Port 1 if the system
contains VTMs.
Serial Port 2 Sharing Enabled, Disabled If enabled, the BMC can use Serial
Port B during BIOS power-on
self-test and also when the
operating system is running.
If disabled, the BMC can use Serial
Port 2 only during BIOS power-on
self-test.
NumLock Auto (default) NumLock is enabled at system boot
if a numeric keypad is detected.
On NumLock is enabled at system
boot.
Off NumLock is disabled at system
boot.
Keyboard repeat rate 30/sec
26.7/sec
21.8/sec
18.5/sec
13.3/sec
10/sec
6/sec
2/sec
Sets the number of times per
second the system repeats a
keystroke while the user
continuously presses the key.
Keyboard repeat delay 1/4 sec
1/2 sec
3/4 sec
1 sec
Sets the delay time that the system
allows between the moment a key
is first pressed and the moment that
the system repeats the keystroke.
Table 5-5. I/O Device Configuration Features (Continued)
Feature Options Description