Technical Reference Guide

ftServer Setup Menus
BIOS Setup 5-11
Figure 5-5. I/O Device Configuration Submenu
Table 5-5 describes the I/O Device Configuration submenu features.
Table 5-5. I/O Device Configuration Features
Feature Options Description
Serial Port 1
Serial Port 2
Note: Serial Port 1 may
not be routed to the
modem if a VTM is
present.
Disabled The selected port is disabled and
the serial port on the motherboard
is not in use.
Enabled You can select the serial port I/O
address and IRQ for the selected
port in the setup menu.
Auto The BIOS or operating system
chooses the configuration.
ftServer Setup
Advanced
I/O Device Configuration
Serial Port 1: [Enabled]
Base I/O address: [3F8/IRQ 4]
Serial Port 1 Connection: [Serial Connector]
Serial Port 2: [Enabled]
Base I/O address: [2F8/IRQ 3]
Serial Port 2 Sharing [Disabled]
Keyboard Features:
NumLock: [Auto]
Keyboard auto-repeat rate: [30/sec]
Keyboard auto-repeat delay: [1/2sec]
Item Specific Help
Peripheral
configuration
F1 Help ↓↑ Select Item -/+ Change Values F9 Setup Defaults
ESC Exit ←→ Select Menu Enter Select
* Sub-Menu F10 Save and Exit