Manualshelf

Technical Reference Guide

ManualsBrandsNEC ManualsserversNEC Express5800/320Ma
31323334353637383940
ftSMC Component Properties
3-14 Express5800/320Ma: Technical Reference Guide
Notify SNPP Port The port number used by the Simple Network Paging Protocol
(SNPP) server for sending a page. Default is port 0.
Notify SNPP Server The IP address of the SNPP server used to send pager messages.
Number of Faults Total number of times the device has failed.
Num of Missed Polls Defines how many polls can be missed between a slave machine
and the ftGateway machine before the slave machine is determined
to be offline.
Number of Retries Number of times that the system attempts to dial each number in
the list of Phone Numbers when attempting to contact NEC
Technical Support or your service representative. A value of 1 (the
default) indicates that the system calls each phone number only
once. A value of zero (0) is invalid.
OEMManufacturer The original manufacturer of the device.
OEM0Enabled Defined by OEM or system integrator. Do not change the default
setting (False) of this property.
OEM1Enabled Defined by OEM or system integrator. Do not change the default
setting (False) of this property.
OEM2Enabled Defined by OEM or system integrator. Do not change the default
setting (False) of this property.
OnlineCpuPriority For CPU elements only. The priority at which the CPU is operating.
Supported values are High and Medium. The priority of other
elements is adjusted accordingly as follows:
If the priority of the specified element is increased, the element with
the same priority has its priority decreased.
If the priority of the specified element is decreased, the element with
the same priority has its priority increased.
Op State: Reason The reason a component is in a particular operational state.
Op State: Reason
None
Indicates that there is no reason associated with the current state.
Op State: Reason
Below MTBF
The current MTBF is below the MTBF threshold specified for this
component.
Op State: Reason
Diagnostics Failed
This component failed diagnostic testing.
Op State: Reason
Hardware Incompatible
The component hardware is incompatible with the online system
hardware.
Table 3-1. ftSMC System Inventory Component Properties (Continued)
Property Description