Technical Reference Guide

ftSMC Component Properties
ftSMC Component Properties and Actions 3-11
LunFlushInterval Interval, in minutes, between flushes of the disk write cache. Default
is 0, disabled.
LunVerifyInterval Specifies the frequency with which information on physical disks
that are configured as mirrors in an RDR virtual disk are compared
to each other. Default: 10800 minutes (7 days)
MachineCheckThreshold Sets the threshold number of errors that sends a Correctable
Machine Check call-home message. The system keeps a record of
the number of Correctable Machine Check errors detected per CPU
element and whether the threshold has been exceeded. Look at
individual processors to see which ones are experiencing problems.
Manufacturer The manufacturer of the device.
MCA Info:
ThresholdExceeded
Indicates if the configured error threshold for Correctable Machine
Check errors, has been exceeded.
Medium Idle Re-send Count The number of re-send attempts, separated by Medium Idle Time
Between Re-sends, that ftServer Manager will make before moving
to the long idle interval.
Medium Idle Time Between
Re-sends
The medium idle time, in seconds, between attempts to re-send an
alarm. After a number, defined by Short Idle Re-send Count, of
unsuccessful attempts to send an alarm message, ftServer
Manager waits this long before it attempts to re-send the alarm.
After a number of unsuccessful attempts, defined by Medium Idle
Re-send Count, ftServer Manager will wait the amount of time
defined by Long Idle Time Between Re-sends before attempting to
re-send the alarm message.
Member Status Identifies whether a system is a member of an ftGateway group or
not, and if it is a member, whether it is a gateway or slave machine.
The default value is Non-member.
Member Status Confirm Provides feedback on the Join ftGateway Group action, which is
described in Tabl e 3- 2. It is set to Confirm Pending after executing
the Join ftGateway Group action. It is then set based on the
feedback status from the gateway adapter. The default value is Not
Applicable.
MemCheckRate Sets the rate at which the driver checks memory. The rate is a
number from 0 to 9, where 0 is the slowest rate and 9 is the fastest.
The default is 5. See Perform Memory Check, which is described
in Tabl e 3 -2.
Messages[n] Contains the text displayed on the front panel LCD.
Model The device’s model number.
Table 3-1. ftSMC System Inventory Component Properties (Continued)
Property Description