User's Guide

8-50 System Upgrade
one paths to a single SCSI bus, specify all of them
3. Repeat step 2 if there is another SCSI bus on the same domain.
4. Confirm the setting on /proc/scsi/topo, and then execute the following command to save
the topology:
ftdisk topology-save
The topology setting will be restored at restart.
CHECK:
When deleting setting items of the topology, delete the
saved topology file from
“rm/opt/nec/ftras/etc/scsi-topology.save”.
Restart the system and then perform the setting from step
1 again.
Configure expanded LAN board
Follow the procedure below to set the dual configuration of the 100BASE-TX, 1000BASE-T,
1000BASE-SX.
Make the following settings after mounting the LAN board according to the description of the
“Installing PCI Board” in “PCI BOARD”.
IMPORTANT: You need to login to the system as a user with a root authority to perform this
operation.
1. Execute the following command to check if the expanded LAN board is displayed properly at
the number of the slot to which the LAN board was added.
>vndctl status
In the following description, “*” (a number between 1 and 7) indicates the number of the PCI
slot to which the LAN board was added.
2. Use the following command to add and register the LAN board expanded to the PCI slot *.
>vndctl add *
3. Execute the following command to set the dual LAN board configuration on the PCI slot *.
>vndctl config *
4. Use the following command to start the dual LAN board on the PCI slot *.
>vndctl up *
Setting dual configuration of the expanded LAN board is now completed. Note that the network
setting above is effective to a virtual device ha* (“*” is a number), however, it is not reflected to
physical devices (e.g., epro* or gb*, * is a number).