Setup Guide

Windows Setup 4-32
7. Click [OK].
8. Check that disk synchronization has
been started and the status of the DISK
ACCESS LED and RDR Utility
display changes
as the following table.
During synchronization
DISK ACCESS
LED
RDR Utility
Condition Status
Synchronization
source disk
Amber and
blinking
Simplex
Synchronization
destination disk
Amber and
blinking
Syncing
RDR Virtual Disk
Simplex
Resync x %
(x=0, 10, 20,…,
90)
IMPORTANT:
- The time required for synchronization deffers depending on the size of
the partition that exists on the disk. As for the partition with the 18GB
capacity, it takes about 16 minutes. If there is no partition,
synchronization completes soon after setting RDR is completed and
the disk changes to the synchronization completion status.
- Setting dual disk configuration may not complete if the system is
rebooted during synchronization. Do not reboot the system before
synchronization process completes.