User's Guide

Configuring Your System 3-19
Table 3-1. SCSISelect Utility Setup Configurations (continued)
OPTION
RECOMMENDED SETTING
OR DISPLAY ONLY
YOUR
CONFIGURATION
Display <Ctrl-A> Messages During BIOS
Initialization
Enabled
Extended Int13 Translation for DOS
Drives >1 GByte
Enabled
POST Display Mode Verbose
SCSI Controller Int13 Support Enabled
1
Domain Validation Enabled
1
Support Removable Disks
Under Int13 as Fixed Disks
Disabled
1, 2
BIOS Support for Bootable CDROM Enabled
1
BIOS Support for Bootable CDROM Enabled
1
1
No effect if BIOS is disabled.
2
Do not remove media from a removable media drive if it is under BIOS control.
SCSI Disk Utilities
This utility scans the SCSI bus for SCSI devices, reports a description of each
device. Run these utilities before configuring SCSI devices.
To enter the utility, select "SCSI Disk Utilities" on the Options menu.
The SCSI ID scan begins displaying the message as shown below.
Scanning SCSI ID : 0 LUN Number : 0
When the SCSI ID scan completes, the screen listing SCSI IDs and associated
devices appears.
Select SCSI Disk and press <Enter>
SCSI ID #0 : No device
SCSI ID #1 : No device
SCSI ID #2 : No device
SCSI ID #3 : No device
SCSI ID #4 : No device
SCSI ID #5 : No device
SCSI ID #6 : No device
SCSI ID #7 : Adaptec AIC-7899
SCSI ID #8 : No device
SCSI ID #9 : No device
SCSI ID #10 : No device
SCSI ID #11 : No device
SCSI ID #12 : No device
SCSI ID #13 : No device
SCSI ID #14 : No device
SCSI ID #15 : No device