User's Guide

2-16 Setting Up the System
Installation Procedure A
1. Attach the Arm Base to the rear of the power supply cage using the two
screws that secure the power supply cage to the chassis. See Figure 2-14.
Figure 2-14. Attaching the Arm Base
2. One end of the cable arm includes a long hinged bracket with six mounting
holes. The other end of the cable arm includes a small hinged bracket with
two mounting holes. Using two 6-32 screws attach the end of the cable arm
with the long hinged bracket to the Arm Base installed in the previous step.
See Figure 2-15.
Arm base
Cable arm
Two 6-32
screws
Figure 2-15. Installing the Cable Arm to the Arm Base
Power Supply
Cage Screws (2)
Arm base