User's Guide

Setting Up Your Server 2-9
Installing the Rail Brackets onto the Sliding Rails
1.
Install a rail bracket onto each sliding rail assembly as shown below.
2.
Line up the screw hole (slot) at the top end of each rail assembly to the screw hole in the
rail bracket, and loosely tighten the screw to temporarily secure the rail assembly and
bracket.
3.
When each rail bracket is installed on the rail assembly, the catch tab at the top end of
the rail bracket should point upwards like the catch tab at the opposite end of the rail
assembly. See the Figure below.
Inner rails
Rear side of the rack
Catch
Catch
Front side of the rack
Rail assembly
Rail bracket
Screw holes
(Use the screw hole in accordance with
the depth of the rack. Lightly tighten the
screw.)