User's Guide

7-40 Upgrading Your Server
!
If an option operating with only 33 MHz is installed in one of the slots (1C, 2C, and 3C,
or 1B, 2B, and 3B) on a PCI riser card, the options installed in the other slots of the same
riser card are subjected to operation with only 33 MHz.
Installing a PCI Board
Perform the following steps to install a PCI board on the riser card:
IMPORTANT:
!
Each riser card supports low-profile or full-height PCI boards. Before
installing a PCI board, confirm that the type of the PCI board.
!
When installing a PCI board, confirm that the card connector matches
the connector of the riser card.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Pull out the server from the rack.
3.
Remove the top cover.
4.
Lift straight up and remove the riser card from the server.
5.
Unlock and open the retainer clip.
Low-profile type Full-height type
Plastic loop
Retainer clip
Retainer clip
Low-profile type Full-height type