User's Guide

Upgrading Your Server 7-27
6.
Install the components removed in steps 2 and 3.
7.
Power on the server and verify that POST displays no error messages.
If POST displays an error message, take note of the message and see the POST error
messages listed in Chapter 6.
8.
Start the SETUP and select [Advanced] → [Memory Configuration] to verify that the
installed DIMM shows the status "Installed". (See Chapter 3 or details.)
9.
Select "Yes" for [Reset Config Data] on the [Advanced] menu.
This setting is required to change the hardware configuration data. See Chapter 3 for
details.
10.
If your operating system is Windows 2000 or Windows NT 4.0, set the paging file size to
the recommended value or a greater value as shown below. See Chapter 4 for details.
– For Windows 2000: Total memory size × 1.5
– For Windows NT 4.0: Total memory size + 12MB
If your operating system is NetWare, reserve the disk space in the MS-DOS partition for
a memory dump.