User's Guide

Troubleshooting 6-33

RECOVERY FOR Windows 2000/Windows NT SYSTEM

If any file necessary for running the OS is damaged, use the following procedures to recover the

system.

IMPORTANT:

After recovering the system, see "Updating the System" in Chapter 4

and be sure to update the system.

Also on Windows 2000, you need to update all the drivers after the

system update. For more information, see "Installing and Setting

Device Drivers" in Chapter 4.

Concerning Windows NT 4.0, in case you updated the system, be sure

to update the recovery information also, which will be the base of

system recovery. (For more information on how to update the

recovery information, see "Updating System Recovery Information" in

Chapter 4.)

Concerning Windows 2000, see "Installing and Setting Device

Drivers" and "Updating the System" in Chapter 4 and be sure to

update both the drivers and the system.

If the hard disk can not be recognized, you can not recover the system.

Recovery Procedure - Windows 2000 -

Follow the procedure below and use the information in the disk, not the system recovery disk, to

recover the system.

Turn on the power of the system.

Insert Windows 2000 CD into the CD-ROM drive of your server.

Press the RESET switch or press Ctrl, Alt,andDelete to reboot the server. (You may

also turn off and then on again to reboot the server.)

Proceed to step 8.

Press F6 while the message "Setup is inspecting your computer's hardware

configuration..." is displayed at the upper part of the screen.

NOTE:

Nothing is changed on the screen through F6 is pressed.