User's Guide

4-44 Installing the Operating System
16. Insert "NetWare 5.X OEM-Disk" diskette. Press ENTER.
17. Highlight and press ENTER for each driver listed below:
MDAC.HAM (displayed only if a RAID board is installed)
ADPT160M.HAM
18. Press ESC.
19. Highlight "Return to Drive Sumary". Press ENTER.
20. Press ESC.
21. Highlight "Continue". Press ENTER.
22. From the Device Driver menu Highlight "Modify". Press ENTER.
23. Highlight "Network Boards". Press ENTER.
24. Press "Insert" key.
25. Press "Insert" key.
26. Press ENTER.
27. Highlight "Return to Driver Summary". Press ENTER
Note:
Repeat steps 25 through 29 for additional Network
Boards.
28. Press ESC and return to "Device Driver Summary".
29. Press ESC.
30. Highlight "Continue". Press ENTER.
31. Highlight "Continue" to create a NetWare partition and volume SYS.
Press ENTER.
32. At the Server Properties box type in your server name and click "Next."
33. At the Protocols box, click the "Network Board" you want to configure.
34. Once you made your network board selection, specify the network protocol for
each network board. Click "Next" to continue.
Note:
If you select IP, fill in the IP address, subnet mask and
router information appropriately.
35. Select your correct time zone. Click "Next" to continue.
36. Select the NDS installation type for this server. Click "Next" to continue.