User's Guide

Installing the Operating System 4-9
Installing Windows 2000
This section describes how to install Windows 2000 using Express Setup.
Prepare the configuration diskette. You can perform the installation without a configuration
diskette prepared in advance, but one floppy disk formatted by MS-DOS 1.44MB will be
required. For the configuration diskette, use the blank disk included with EXPRESSBUILDER
or prepare a floppy disk.
IMPORTANT:
!
If you modified the system configuration, execute "System Update".
!
If you want to modify or add a graphic accelerator driver or network
adapter driver, see Appendix D.
1.
Power up peripheral devices, and then power up the server.
2.
Insert the EXPRESSBUILDER CD into the CD-ROM drive.
3.
Press the RESET switch or press Ctrl, Alt, and Delete to boot the EXPRESSBUILDER
CD. (You may also power down, then power up, to reboot the server.)
The system boots from the CD and EXPRESSBUILDER starts.
4.
The "Language Selection Menu" is displayed. Select the language and keyboard to be
used to perform Express Setup.
5.
Click [Express Setup].
"Note" will be displayed.
6.
Read the instruction carefully and click [OK].
The message "Insert configuration diskette" appears.
7.
Insert the configuration diskette into floppy disk drive and click [OK].
NOTE: If you do not have a configuration diskette, insert a blank
1.44MB formatted floppy disk into the floppy disk drive and click [OK].