User's Guide

System Overview 1-5
7 3.5-inch floppy disk drive
This drive reads/writes data from/to the 3.5-inch floppy diskette.
7
-1 Disk access lamp
7-2 Disk slot
7-3 Eject button
8 Backup device bay
Mount an optional DAT or AIT drive in this bay.
9 Front serial port 2 connector
Connect a device having a serial interface to this connector.
10 USB connectors (2 ports)
Connect device compliant with the USB interface to the connectors. (Windows NT 4.0
requires a compliant driver.)
11 Lamps (See the previous figure for a description of these six lamps.)
12 POWER switch
Press this switch to turn the server on/off. Pressing the switch once turns on the power, and
the POWER lamp is lit. Pressing this switch again turns off the power. Once power is
applied to the server, pressing this switch for 4 seconds or more turns off the power.
13 Reset switch
Press this switch to reboot the server.
14 DUMP switch
Press this switch to dump system memory.
15 UID (unit ID) switch
Press this switch to turn the UID lamps on/off on the front and rear panels of the server.
Pressing the switch once turns the lamps on. Pressing this switch again turns the lamps off.