User's Guide

2-20 Setting Up the System
Rear View
Figure 2-19 shows the location of the rear system features and controls.
ABC
DE
F
GHIJKLMNOPQ
A 33 MHz, 64-bit PCI slot Three 33 MHz, 64-bit PCI add-in board slot locations
B
Wide Ultra 2 SCSI Connector Connects external SCSI devices with internal SCSI or RAID
controller. Note: This connector is not connected internally unless a
RAID controller is factory installed in the system.
C Power supply door Power supply located behind this door.
D
Power supply status
(Green LED)
When green, AC power supplied to power supply
when OFF, no AC power supplied to the power supply
E
Power supply fault
(Red LED)
When red, power supply failed
F Power supply door Open to install a second redundant power supply. Power supplies
are hot-swappable when two power supplies are installed.
G AC input power connector Supplies AC power to the power supply
H Mouse port PS/2-compatible 6-pin mini-DIN connector (Green)
I Keyboard port PS/2-compatible 6-pin mini-DIN connector (Purple)
J Serial Port 1 COM1 serial port 9-pin connector (Turquoise)
K Serial Port 2 COM2 serial port 9-pin connector (Turquoise)
L USB1 connector
First USB connector (Black) Note: Factory default for USB Ports is
“Disabled.” Run the BIOS Setup Utility to enable.
M USB2 connector
Second USB connector (Black) Note: Factory default for USB
Ports is “Disabled.” Run the BIOS Setup Utility to enable.
N LAN connector RJ-45 Ethernet connector
O SVGA connector SVGA monitor 15-pin connector (Blue)
P Printer port (Burgundy) Parallel port 25-pin connector (Burgundy)
Q Memory Dump Button Press to dump system memory.
Figure 2-19. Rear Features and Controls