User's Guide

System Overview 1-3
As application requirements increase, you can expand your server with an additional
processor, additional memory, add-in boards and peripheral devices: tape devices,
CD-ROM, and hard disk drives.
Your server features the following major components:
!
Single or dual high-performance Pentium III processors.
!
64 MB to 4 GB of memory, using up to four DIMMs.
!
Three 64-bit/33Mhz PCI expansion slots and one 32-bit/33Mhz PCI expansion
slot for add-in boards.
!
Embedded PC-compatible support (serial, parallel, mouse, keyboard, diskette,
USB, LAN, and video).
!
Integrated onboard ATI RAGE IIC Super Video Graphics Array (SVGA)
controller with 4 MB of video memory.
!
Adaptec AIC7899 SCSI controller providing Wide Ultra2 and Ultra-160/M SCSI
interfaces.
!
Integrated onboard Network Interface Controller (NIC), an Intel 82559 PCI LAN
controller for 10 or 100 Mbps Fast Ethernet networks with an RJ-45 Ethernet
connector.
!
Single Channel enhanced IDE controller.
!
A slim design CD-ROM drive and 3 ½-inch diskette drive installed in a single
bay.
!
Integrated dual Universal Serial Bus (USB) ports.
!
Hardware monitors (temperature, fans, and voltage) and software monitors to
indicate failures.
!
Redundant cooling fans.
!
A 330-watt power supply; a second optional 330-watt hot-swap redundant power
supply is available for your server.
!
Keylocked front cover, including an intrusion switch.
Hot-Swap SCSI Hard Drive Bays
!
Five hot-swap 1.0-inch SCSI hard disk drive bays accessible from the front of
the chassis can be swapped in or out of the system without powering it down if
RAID is configured in the system.
!
High degree of SCSI disk fault tolerance and advanced disk array management
features through the use of RAID technology, if an optional RAID controller is
installed.
!
SCSI controller, cables, backplane and devices are Ultra160/M ready.