User's Guide

Setting Up the System 2-13
Disk Drive Status Conditions
Condition LED
No Error Off
Faulty or Rebuild Stopped Steady ON
Rebuild Slow Blink for approximately one second
Identify Fast Blink for approximately three seconds
Predicted Fault Four fast blinks, pause (repeats)
Making Connections
If your system normally operates without a video display or keyboard (for
example, as a network server), you must install a video display and keyboard to
configure the system. You may remove them after running the BIOS Setup
Utility. For information on running the BIOS Setup Utility, refer to Chapter 3
"Configuring Your System" of this User’s Guide.
Refer to the previous figure (Rear Features and Controls) and connect your
keyboard, monitor, and mouse. Connect any external peripheral devices such as
a printer or modem by following the instructions included with these devices.
!
CAUTION
Damage to the system may result if the keyboard/mouse
cable is inserted or removed when power is applied to the
system.
Inserting a telephone line connector into a LAN board RJ-45
port may result in personal injury and equipment damage.