User's Guide

4-22 Configuring Your Server
SCSI Disk Utilities
This utility scans the SCSI bus for SCSI devices, reports a description of each device. Run these
utilities before configuring SCSI devices.
To enter the utility, select "SCSI Disk Utilities" on the Options menu.
The SCSI ID scan begins displaying the message as shown below.
Scanning SCSI ID:14: Lun Number
AIC-7901 at Slot 00. 23 03:03:00
When the SCSI ID scan completes, the screen listing SCSI IDs and associated devices appears.
Find out the SCSI ID for the installed optional on this screen. You can also view the device
information by selecting a device and pressing Enter.
The following sub menu appears.
SCSI ID#4 : xxxxxxxxx
Firmware : xxxx xxx
Capacity : xxGB
Format
Verify Disk Media
The following table lists submenu items and descriptions.
Submenu item Description
Format Formats the selected device in the raw level.
Verify Disk Media Verifies all the sectors in the selected device. If one or
more bad sectors are found, reassigns the sectors.
HostRAID
Move the cursor onto "HostRAID" and press Enter to choose the HostRAID option.
Submenu item Parameter Description
HostRAID Enabled
[Disabled]
Select "Disabled" if the onboard HostRAID
controller is not used.
[ ]: Factory-set
NOTE: For detail explanation on the HostRAID feature, see
SCSISelect Utility User's Manual and Adaptec Storage Manager
TM
-
Browser Edition User's Guide. You may view or print the SCSISelect
Utility User's Manual and Adaptec Storage Manager
TM
- Browser
Edition User's Guide from the NEC EXPRESSBUILDER CD-ROM.