Release Notes

4 Express5800/120Lf System Release Notes
!
EXPRESSBUILDER Express Setup does not support installation of
Windows 2000 Service Pack 2. After installing Windows 2000, close
Express Setup, remove the EXPRESSBUILDER CD, and install Windows
2000 Service Pack 2 using the Microsoft Service Pack 2 media.
!
Unspecified results may occur if Windows NT 4.0 is installed without using
EXPRESSBUILDER Express Setup. Always use EXPRESSBUILDER
Express Setup when installing Windows NT 4.0 Server with Service Pack 6.
!
If you already have an operating system installed when creating a
maintenance partition, EXPRESSBUILDER will warn you of the existing
partition. If you want to preserve the installed operating system, do not
create the maintenance partition or the existing operating system will be
overlaid by the maintenance partition.
!
The Administrator Menu in the System Information Management segment
of the Offline Maintenance Utility is accessible only by NEC authorized
service representatives.
!
EXPRESSBUILDER operates in floppy emulation mode. The emulated
floppy drive portion of your system CD-ROM is designated Drive A and the
remaining portion(s) of the CD-ROM is designated Drive Q. Your system
diskette drive is Drive B. After creating the Off-line Maintenance Utility
diskette, EXPRESSBUILDER prompts you to remove the diskette from
Drive B. At this prompt, remove the diskette from your diskette drive.
!
The server must be powered OFF in order to perform an MWA connection
check.