Release Notes

Express5800/120Lf System Release Notes 3
Introduction
These System Release Notes cover the following topics:
!
General Comments
!
Advisories
!
Documentation Errata
General Comments
The following general comments apply to this server.
!
Versions of the Network Operating Systems tested and recommended are:

Windows
®
2000 with Service Pack 2

Windows NT
®
4.0 Server with Service Pack 6

Novell
®
NetWare
®
5.1

SCO OpenServer
™
5.06.
Advisories
EXPRESSBUILDER
The following advisories apply to EXPRESSBUILDER.
!
EXPRESSBUILDER Express Setup always configures the Windows 2000
TCP/IP Protocol IP settings to "Obtain an IP address automatically"
(DHCP), regardless of the IP address setting specified in Express Setup. If
static TCP/IP addressing is required, TCP/IP must be reconfigured. Refer to
Windows documentation for instructions.
!
After installing Windows 2000, the Windows 2000 Device Manager may
show an NEC GEM SCSI Processor Device and/or an Unknown Device
under Other Devices. The Unknown Device is a reference to the baseboard
management controller. Installing the ESMPRO Agent can clear both of
these conditions.
!
Windows 2000 and Windows NT 4.0 must be installed using
EXPRESSBUILDER Express Setup to take full advantage of NEC specific
software for your server.
Note:
This advisory does not apply if your operating
system was preloaded at the factory.