Release Notes

Express5800/120Ee System Release Notes 3
Introduction
These System Release Notes cover the following topics:
!
General Comments
!
Advisories
General Comments
The following general comments apply to this server.
!
Versions of the Network Operating Systems tested and recommended are:

Windows
®
2000 with Service Pack 2

Windows NT
®
4.0 Server with Service Pack 6

Novell
®
NetWare
®
5.1
Advisories
EXPRESSBUILDER
The following advisories apply to EXPRESSBUILDER.
!
EXPRESSBUILDER Express Setup always configures the Windows 2000
TCP/IP Protocol IP settings to "Obtain an IP address automatically"
(DHCP), regardless of the IP address setting specified in Express Setup. If
static TCP/IP addressing is required, TCP/IP must be reconfigured. Refer to
Windows documentation for instructions.
!
Windows 2000 and Windows NT 4.0 must be installed using
EXPRESSBUILDER Express Setup to take full advantage of NEC specific
software for your server.
Note:
This advisory does not apply if your operating
system was preloaded at the factory.
!
EXPRESSBUILDER Express Setup does not support installation of
Windows 2000 Service Pack 2. After installing Windows 2000, close
Express Setup, remove the EXPRESSBUILDER CD, and install Windows
2000 Service Pack 2 using the Microsoft Service Pack 2 media.
!
If you already have an operating system installed when creating a
maintenance partition, EXPRESSBUILDER will warn you of the existing
partition. If you want to preserve the installed operating system, do not
create the maintenance partition or the existing operating system will be
overlaid by the maintenance partition.