User's Guide

4-12 Upgrading Your System
8. Orient the heat sink as shown in Figure 4-10 and install the thermal tape
square onto the heat sink in the exact position shown.
Figure 4-10. Installing Thermal Tape
9. Position the heat sink above the processor so the thermal tape square
attached to the bottom of the heat sink is directly positioned above the
processor.
!
CAUTION
When performing the next three steps, be sure the heat sink
is held firmly in position. If the heat sink should slide across
the top of the processor, the thermal tape may be damaged.
10. Position the heat sink clip over the center of the heat sink and attach the
small end of the clip to the tab located on the base of the ZIF socket. See
Figure 4-11, A.
A
Figure 4-11. Positioning the Heat Sink Clip
11. Insert a flat blade screwdriver into the tab of the retention clip.
12. Secure the clip onto the tab of the ZIF socket.