User's Guide

Configuring Your System 3-19
Configuring System Board Jumpers
Before You Begin
Only a qualified technical person should perform the procedures in this section.
!
CAUTION
Electrostatic discharge (ESD) can damage the system
board. Modify the system board only at an ESD workstation.
Otherwise, wear an antistatic wrist strap attached to chassis
ground.
The system board jumpers enable you to set specific operating parameters for
your system. A jumper is a small plastic-encased conductor (shorting plug) that
slips over two jumper pins.
Figure 3-1 shows the location of the system board jumpers. Table 3-3 lists the
system board jumpers and their factory default settings.
1357 911
2 4 6 8 10 12
Figure 3-1. System Board Jumpers