User's Guide

System Cabling A-5
RAID Configuration
The RAID options available for your system provide your system with the added
security of fault tolerance.
If you order a system with a RAID controller, the system is pre-cabled at the factory as
shown in Figure A-2.
If you are adding a RAID controller you must install, cable, and configure the
controller. Refer to "Installing a RAID Controller Board" in Chapter 4.
A
B
C
D
E
F
G
H
I
J
K
N
L
M
O
A – Diskette drive connector I – Optional SCSI removable media devices
B – Diskette interface cable J – RAID Controller
C – Diskette drive K – Ultra-160/M SCSI interface cable
D
– IDE connector
L
– Five SCSI disk drive bays
E – IDE interface cable M – Drive Bay
F – IDE CD-ROM drive N – SCSI hard disk drives
G – Ultra2 SCSI connector (68 pin) O – System board
H – Ultra2 SCSI interface cable
Figure A-2. RAID System Cable Configuration