User's Guide

4-18 Configuring Your Server
See the table below for the options and their descriptions:
Option Parameter Description Your Setting
Set User
Password
Up to 7
alphanumeric
characters
Press
Enter
to display the User password
entry screen. With a User password, the
available SETUP menus are restricted. This
option is available only if the Supervisor
password is set.
Set Supervisor
Password
Up to 7
alphanumeric
characters
Press
Enter
to display the Supervisor
password entry screen. With the Supervisor
password, all SETUP menus are available.
This option is available only when you log
into the SETUP utility with the Supervisor
password.
Password on
boot
[Disabled]
Enabled
Specify whether to request password entry
on boot. User password setup is required
beforehand. When the supervisor password
is specified and this option is disabled, the
BIOS assumes that a boot attempt is made
by a user.
It gives priority to "Secure Mode Boot" when
"Secure Mode Boot" and "Password on boot"
are both enabled.
Secure Mode
Timer
[Disabled]
1 min
2 min
5 min
10 min
20 min
60 min
120 min
Specify the idle period for the system to enter
Secure Mode. If this item is set to [Disabled],
the timer is unavailable.
Hot Key
(CTRL+ALT+)
[L]
Z
Specify the key to enter Secure Mode. Press
the selected key while pressing Ctrl and Alt
to enter Secure Mode.
Secure Mode
Boot
[Disabled]
Enabled
Specify whether the system starts in Secure
Mode or not.
Power Switch
Inhibit
[Disabled]
Enabled
Specify whether the POWER switch of the
CPU blade is enabled or disabled. If
Enabled, the POWER switch cannot be used
to power off the CPU blade. The forced
shutdown procedure (pressing the POWER
switch for at least 4 seconds) is still available.
[ ]: Factory-set
IMPORTANT: Secure Mode is used to restrict the access of a user
who has no user password.
In Secure Mode, the POWER switch, DUMP switch, keyboard, and
mouse are disabled, and the ScrollLock, CapsLock, and NumLock
lamps on the keyboard flashsequentially.
To exit Secure Mode, enter the user password.