User's Guide

- 40 -
25> Enter 1(via WWPN). Then, you will see the Boot device’s settings window again. Confirm that
the top item on the list is “USED.”
Adapter 01: S_ID:000001 PCI Bus #:07 PCI Device #:00
The Boot Device is: DID: 000000 WWPN:20000000 4C123456 LUN:00
List of Saved Boot Devices:
9. Used DID:000000 WWPN:21000000 4C123456 LUN:00 Primary Boot
10. Unused DID:000000 WWPN:00000000 00000000 LUN:00
11. Unused DID:000000 WWPN:00000000 00000000 LUN:00
12. Unused DID:000000 WWPN:00000000 00000000 LUN:00
13. Unused DID:000000 WWPN:00000000 00000000 LUN:00
14. Unused DID:000000 WWPN:00000000 00000000 LUN:00
15. Unused DID:000000 WWPN:00000000 00000000 LUN:00
16. Unused DID:000000 WWPN:00000000 00000000 LUN:00
Select a Boot Entry:_
Enter <x> to Exit <Esc> to Previous Menu
26> Press the <ESC> key to return to the following menu:
Adapter 01: PCI Bus #:07 PCI Device #:00
LPe1105-N I/O Base: 4000 Firmware Version: ZS2.50A8
Port Name: 10000000 C92B6B74 Node Name: 20000000 C92B6B74
Topology: Auto Topology: Loop first (Default)
1. Configure Boot Devices
2. Configure This Adapter's Parameters
Enter a Selection: _
Enter <x> to Exit <d> to Default Values <Esc> to Previous Menu
27> Select “2.” Then, you will see the following settings window:
Adapter 01: PCI Bus #:07 PCI Device #:00
LPe1105-N I/O Base: 4000 Firmware Version: ZS2.50A8
Port Name: 10000000 C92B6B74 Node Name: 20000000 C92B6B74
Topology: Auto Topology; Loop first (Default)
10. Enable or Disable BIOS
11. Change Default ALPA of this adapter
12. Change PLOGI Retry Timer (+Advanced Option+)
13. Topology Selection (+Advanced Option+)
14. Enable or Disable Spinup delay (+Advanced Option+)
15. Auto Scan Setting (+Advanced Option+)
16. Enable or Disable EDD 3.0 (+Advanced Option+)
17. Enable or Disable Start Unit Command (+Advanced Option+)
18. Enable or Disable Environment Variable (+Advanced Option+)
A. Auto Sector Format Select (+Advanced Option+)
Enter a Selection: _
Enter <x> to Exit <Esc> to Previous Menu