User's Guide

- 37 -

Change BIOS settings

When you have done all of the above-mentioned preparations, follow the instructions below to

change this product’s BIOS settings (registering Boot device and enabling Boot BIOS).

16> Confirm that the CPU Blade system is properly connected to the Fiber Channel device. Then, turn

on the CPU Blade.

Hint

 If the logo is displayed but the BIOS window is not, press the <ESC> key to

display it.

17> Hold the <Alt> key and press <E> while the following message is displayed. Then, the product’s

BIOS menu will appear.

Press <Alt E> To Go To Emulex BIOS Utility

Press <S> To Skip Emulex BIOS

Important

 This product’s BIOS settings window consumes a lot of memory. Therefore,

depending on your environment (example.g., an expansion board is consuming a

lot of memory), this window may not be displayed or you may not be able to

change the settings. In this case, disable the extended ROM on the CPU Blade

or take other measures. Refer to the CPU Blade’s User’s Guide for information

on how to disable the extended ROM.

18> When the CPU Blade detects that the <Alt> and <E> keys are pressed, you will see the following

messages and the menu:

Bring the Link up, Please wait…

Emulex Light Pulse BIOS Utility, ZB1.70A3

Emulex Adapters in the System:

3. LPe1105-N: PCI Bus #:07 PCI Device #:00

4. LPe1105-N: PCI Bus #:07 PCI Device #:00

Enter a Selection: _

Enter <x> to Exit

Hint

 If the above menu is not displayed and the window has gone on to the next

one, press the <Alt>, <Ctrl>, and <Del> keys simultaneously to reboot the

CPU Blade. Then, follow the steps from the beginning.

 The above message sample is for your reference. The message may be

different depending on the CPU Blade or its configuration.