Electronics America Server User Manual

Disassembly and Reassembly 4-39
Installation
1. Prepare your system for upgrade. See Preparing Your System for
Disassembly and Reassembly described earlier in this chapter.
2. Remove the side cover.
3. Remove the two screws fixing the dummy cover. See Figure 4-39.
4. Pull out the dummy cover toward you carefully.
NOTE: When installing a full-height device, remove two dummy covers.
Figure 4-39. Removing Dummy Covers
5. Attach the rails to the 5.25-inch device by using the four screws. See Figure
4-40.
Figure 4-40. Attaching the Rails
IMPORTANT: When installing a double-height device, use the DLT
device rails that is included with the server.