user manual

CHAPTER 4 ND-45504 (E)
Page 70 Addendum-001
Revision 2.1 JULY, 1998
PN-CK00 (PLO)
(3) Switch Settings
The figure in the SWITCH NAME column and the position in in the SETTING POSITION
column indicate the standard setting of the switch. When the switch is not set as shown by the figure and
, the setting of the switch varies with the system concerned.
Switch Settings
SWITCH NAME
SWITCH
NUMBER
SETTING
POSITION
FUNCTION CHECK
MB (Toggle SW)
Note
UP For make-busy
For normal operation
SW0 (Piano Key SW)
1, 2
Selection of PLO 0 (Phase Locked Oscillator)
3, 4
Selection of PLO 1 (Phase Locked Oscillator)
5 ~ 7 Not used
8
ON PLO frequency hold circuit OFF
PLO frequency hold circuit ON
ON
DOWN
ON
OFF
8
7
6
5
4
3
2
1
SWITCH NUMBER
FUNCTION
12
ON ON
2 MHz clock
[For PN-30DTC/PN-30DTC-A/
PN-2BRTC]
OFF ON
1.5 MHz clock
[For PN-24DTA/PN-24DTA-A]
ON OFF
192 kHz clock
[For PN-BRTA]
OFF OFF Not used
SWITCH NUMBER
FUNCTION
34
ON ON
2 MHz clock
[For PN-30DTC/PN-30DTC-A/
PN-2BRTC]
OFF ON
1.5 MHz clock
[For PN-24DTA/PN-24DTA-A]
ON OFF
192 kHz clock
[For PN-BRTA]
OFF OFF Not used
OFF
OFF