user manual

CHAPTER 4 ND-45504 (E)

Page 36 Addendum-002

Revision 2.2 OCTOBER, 1998

PN-CP03/PN-CP03-C (MP)

The figure in the SWITCH NAME column and the position in in the SETTING POSITION col-

umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and

, the setting of the switch varies with the system concerned.

Note: Set the groove on the switch knob to the desired switch position.

Switch Settings (Continued)

SWITCH NAME

SWITCH

NUMBER

SETTING

POSITION

FUNCTION CHECK

SW2 (Piano Key SW)

2, 3

• When using the PLO card (PN-CK00):

SW2-2

SW2-3

OFF ON

• When not using the internal PLO and the PLO card:

SW2-2

SW2-3

OFF OFF

ON When using RS1 port for built-in MODEM

OFF When using RS1 port for RS-232C.

VR (Rotary SW)

Variable Resister for External Hold Tone

Source

(0 - 20 K

Ω

: Clockwise)

JP0 (Jumper pin)

For normal operation

Memory backup connected

DOWN

For factory testing

(Disconnect battery for memory backup.)

JP1 (Jumper pin)

For normal operation

DOWN For using External Tone Source

CAUTION

When the operating power is being supplied to this circuit card, do not plug/unplug this circuit card into/from its

mounting slot. When the CP03/CP03-C is plugged in and power is on, do not move Jumper JP1.

OFF

Front