user manual

CHAPTER 4 ND-45504 (E)

Page 30

Revision 2.0

PN-CP00 (MP)

The figure in the SWITCH NAME column and the position in in the SETTING POSITION col-

umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and

, the setting of the switch varies with the system concerned.

Note:

Set the groove on the switch knob to the desired switch position.

Switch Settings (Continued)

SWITCH NAME

SWITCH

NUMBER

SETTING

POSITION

FUNCTION CHECK

SW2 (Piano Key SW)

2, 3

• When using the PLO card (PN-CK00):

SW2-2

SW2-3

OFF ON

• When not using the internal PLO and the PLO card:

SW2-2

SW2-3

OFF OFF

4Not used

JP0 (Jumper pin)

LEFT For factory testing

For normal operation

JP2 (Jumper pin)

For normal operation

Memory backup connected

DOWN

For factory test only

Disconnect battery

CAUTION

When the operating power is being supplied to this circuit card, do not plug/unplug this circuit card into/from its

mounting slot.

OFF

Front

RIGHT