user manual

CHAPTER 3 ND-45504 (E)
Page 14 Addendum-001
Revision 2.1 JULY, 1998
3. INSTALLATION CONDITIONS FOR APPLICATION CIRCUIT CARDS
1. When the system is equipped with only one PIM:
• An application circuit card can be mounted in the AP0 through AP6, and AP8 slots.
• An application circuit card can not be mounted in the AP6 slot if any of the following is true.
– A PN-2DLCC is used.
– A PN-AP01 is used.
– OAI, ACD, No. 7 CCIS or ISDN is used.
– The PN-CP02s are used.
2. When the system is equipped with more than one PIM:
• An application circuit card can be mounted in the AP0 through AP5 slots of PIM0/PIM(D)0.
• An application circuit card can be mounted in the AP0 through AP6 slots of PIM2, 4 and 6.
• An application circuit card can be mounted in the AP0 through AP7 slots of PIM1, 3, 5 and 7.
• If the system is equipped with CP02s, the AP5 and AP6 slot of PIM(H)0 cannot be used for an appli-
cation circuit card.
Note 1:
The application circuit card (PN-24DTA/PN-24DTA-A/PN-30DTC/PN-30DTC-A) cannot be mounted
in either the AP7 or the AP8 slot since neither of these slots have a connection to the MDF through the
Back Wiring Board.
Note 2:
The application circuit card (PN-24DTA/PN-24DTA-A/PN-30DTC/PN-30DTC-A [DT10, DT11] which
receives a clock signal must be mounted in the AP0 through AP5 slots of PIM0/PIM(H)0.
Note 3:
The application circuit card (PN-CK00) must be mounted in the AP0 through AP6 slots of PIM0/
PIM(H)0.
Note 4:
The application circuit card (PN-CC00/PN-CC01) can be mounted in any one of the LT slots or the AP
slots.
PN-CC00 card needs two LT/AP slots per one card.
Note 5:
The application circuit card (PN-CC00/PN-CC01) should be mounted in a LT/AP slot that adjoins an
AP slot for the PN-AP01 card because the cable (48-TW0.3 CONN CA) is connected between the PN-
CC00/PN-CC01 card and the PN-AP01 card.