user manual

ND-45504 (E) CHAPTER 3

Addendum-002 Page 11

OCTOBER, 1998 Revision 2.2

2. INSTALLATION CONDITIONS FOR CONTROL CIRCUIT CARDS

2.1 PN-CP00/PN-CP00-B/PN-CP00-C (MP)

Mount the PN-CP00/PN-CP00-B/PN-CP00-C in the MP slot of PIM0.

2.2 PN-CP01 (FP)

1. The PN-CP01 is required only if any of the following is true.

• More than one PIM is used.

• A PN-2DLCC is used.

• A PN-AP01 is used.

• OAI, ACD, No. 7 CCIS or ISDN is used.

2. When the system is equipped with two PIMs, mount one PN-CP01 in the FP slot of PIM0. When the sys-

tem is equipped with more than two PIMs--depending on the number of additional PIMs used--mount one

PN-CP01 in the FP slot of PIM0 and one PN-CP01 in the MP/FP slot of PIM2, PIM4 and PIM6.

Figure 3-2 MP/FP Card Mounting Slots

PIM3 PIM7

PIM2 PIM6

PIM1 PIM5

PIM0 PIM4