user manual

ND-45504 (E) CHAPTER 3
Addendum-002 Page 9
OCTOBER, 1998 Revision 2.2
CHAPTER 3 CIRCUIT CARD INSTALLATION CONDITIONS
This chapter explains the conditions for installing various kinds of circuit cards used in the PBX.
1. CIRCUIT CARD MOUNTING SLOTS
Figure 3-1 below shows circuit card mounting slots allocated in the PIM based on circuit card type.
Figure 3-1 Circuit Card Mounting Slots
FP/AP6
MP/FP/AP7
LT05 LT04 LT03 LT02 LT01 LT06 LT07
LT00 - LT15 : Line/trunk circuit card mounting slots
AP0 - AP8 : Application circuit card mounting slots
MP : PN-CP00/PN-CP00-B/PN-CP00-C mounting slot
FP : PN-CP01 mounting slots
BUS : PN-BS00-A/PN-BS00-B, PN-BS01-A/PN-BS01-B mounting slot
PWR : PZ-PW86 mounting slot
*1 Either line/trunk circuit cards or application circuit cards can be mounted in these slots.
*2 PN-CP01 or an application circuit card is to be mounted in this slot according to the system
configuration.
*3 PN-CP00/PN-CP00-B/PN-CP00-C, PN-CP01 or an application circuit card is to be
mounted in this slot according to the system configuration.
*4 PN-BS00-A/PN-BS00-B, PN-BS01-A/PN-BS01-B or an application circuit card is to be
mounted in this slot according to the system configuration.
BUS/AP8
BUILT-IN BATTERY
PIM0 - 7
LT15/AP5 LT14/AP4 LT13/AP3 LT12/AP2 LT11/AP1 LT10/AP0
LT09 LT08 LT00
PWR
*1 *2 *3 *4