Datasheet

ManualsBrandsNEC ManualsProjectors50031737

VT695/VT595/VT590

VT490/VT59/VT49

DVI input connector (DVI-I) and HDCP compatible (VT695 and VT595 only)

With the DVI-I input connector (DVI-I), the projector can display digital RGB images. By using the DVI-RGB adapter, analogue RGB signals can be

connected from two computers. The DVI-I input connector supports HDCP.

Quick start & quick cool down

Eight seconds after turning on the power, the projector is ready to display PC or video images. Powering down, the fans stop 30 seconds

after turning off the power from the remote control or cabinet control panel. The projector can be stored immediately after powering down.

The main power for the projector can be turned off by either pressing the main power switch or by unplugging the power cable, even

during the cool down period after the projector is turned off.

Auto Vertical Keystone Correction adjusts the trapezoidal distortion to correct the projected image

(VT695 and VT595 only)

If the position of the screen is too high or low, the projector must be installed

at an angle, resulting in trapezoidal distortion of the projected images. The

acceleration sensor built into the main unit senses the inclination of the unit

in the vertical direction and then corrects for any trapezoidal distortion in the

projected image automatically to project square images (+/- 30 degrees from

the projection angle). Projector setup is quick and easy as manual correction

is not necessary. Manual vertical Keystone Correction is available on the

VT590/VT490/VT59/VT49.

Wall Colour Correction for vivid images even without a screen

Without a screen, projected images are affected because of the colour of the

wall or blackboard you are projecting on to. The built-in colour correction for

projecting images on a coloured wall or blackboard in this projector means

that the colour tones of the projected image is approximate to those that are

projected on to a white screen. The following eight colour options are available

: blackboard, blackboard (grey), light yellow, light green, light blue, sky blue,

light rose, and pink.

Very quiet operation in Eco Mode

Eco Mode operation drops projector noise to 25 dB for very quiet operation (VT59/VT49) and extends the lamp

replacement period up to a maximum of 4000 hours (VT59/VT49). In this mode, total cost of ownership can be effectively

reduced. The projector can be put in to Eco Mode very easily with a button on the remote control.

Easy to Use Quick Start

●Manual Zoom

VT695/595/590/490/59

●Digital Zoom

VT49

●Terminal Panel

VT695/VT595

●Terminal Panel

VT590/VT490/VT59/VT49

Model

VT695

VT595

VT590

VT490

VT59

VT49

Resolution

XGA

SVGA

XGA

SVGA

Brightness

2500 ANSI lumens

2000 ANSI lumens

1600 ANSI lumens

Zoom

Manual Zoom

Digital Zoom

Computer Input

Analog with DVI-I

Analog

Speaker

From Digital Cinema to Mobile Convenience - NEC Projector is the Best Solution

Auto start

Turns the projector on automatically when the power cable is inserted into an active power outlet. This eliminates the need to use the

POWER button on the remote control or projector cabinet.

*To use Auto Start, first set the main power switch to "On" before plugging in the power cable.

Built-in speaker for integrated audio solutions

The built-in monaural speaker (5W for VT695/VT595 and 1W for VT590/VT490/VT59/VT49) on the main unit outputs audio from computer,

video, and S-video inputs.

Security function prevents unauthorized use or theft

Password access prevents unauthorized use of the projector. Once the security function is activated, a message requesting the password

is displayed when the power of the main unit is turned on. It is not possible to project an image unless the correct password is entered.

Carrying handle for easy transport

The supplied carrying handle can be installed on the main unit for easy transportation. (VT695/VT595/VT590/VT490 only)

Remote Mouse Operation

You can use the supplied wireless remote control and the optional remote mouse receiver to control your PC from

across the room. The optional remote mouse receiver (NP01MR) supports almost any PC with a USB connection.

Supports component signals

Preset function for setting and storing your favorite colour settings

HDTV (1080i, 720p) and SDTV (576p, 480p) compatibility

Short focal length lens

Quiet Operation

NP01MR(Option)